![]() Use a heat gun to heat the outer edges of the display to about 60☌ (140☏). If the screen is severely cracked, cover all of it with packing tape before you continue. To lift the front panel, you need a suction cup, a hard plastic pick and a heat gun.However neither of these issues will cause the rebooting. ![]() If the flex was torn or the part where the flex is soldered to the pad was damaged or disconnected, then wireless charging may be affected. Small scrapes to the black part should not affect the functionality. Regarding the charging coil, you can check whether the phone wireless charges still. It's best to put everything that was in the phone back the way it was but one missing bracket screw is not the end of the world and shouldn't cause issues. The good news is that your phone is not toast and you haven't done anything irrepairable, the bad news is that you will probably need to replace your charging port again.Īs for the other issues you mentioned: the phone will function perfectly fine if you forgot one of the screws for the bracket. See this question for more information (different model, but same issue). To verify this issue you can check the panic logs (search "Analytics" in settings, look for a file called "panic-full-xxx.ips" under Analytics Data). ![]() Since you replaced the lightning port here I suspect this is the issue. If this sensor is damaged or missing (as it may be on poor quality 3rd party parts), the device will reboot itself every 2 minutes and 50 seconds if the screen is on (it won't reboot while locked). On iPhones released after the iPhone X there is a sensor on the charging port flex that communicates with the CPU. A pity since it is still quite new and worked perfectly apart from the headphones issue. I don't think any repair shops will take my phone, much less any apple-certified technicians and can't get any money for it so at this point my only solution is to toss it and get a new phone. The thing that was really tricky was to get the little coax connector of the antenna convertor cable to fit on the new lightning port assembly, but it seemed to fit just fine and wifi and 4G still works perfectly. Is there any other solutions I could try? Any specific hardware that I could trouble shoot? When replacing the lightning port assembly almost all components were removed so could be anything, but I feel like I managed to put everything back together where it should.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |